CraftBot FLOW generation Firmware update

Windows and Linux users FW update Installation

Download the latest Firmware for the FLOW 3D printers at https://craftbot.com/firmware
Copy CRAFT_UPDATE.ZIP to a FAT32 formatted usb drive
Put the pendrive in to the HMI port
Wait for the pendrive icon appear on the top right corner of the screen
Go to SETTINGS and then UPGRADE menu
Press the RESCAN button until UPDATE FROM PENDRIVE appears
Tap the UPDATE FROM PENDRIVE to start the update process
Update is automatic, when it is ready, click on the UPDATE FINISHED OK button

MAC users

Please ensure you disable the automatic extraction of ZIP files in SAFARI browsers
This guide shows how to disable the ZIP file extraction:
https://macreports.com/how-to-download-zip-files-without-unzipping/

Download the latest Firmware for the FLOW 3D printers at https://craftbot.com/firmware
Copy CRAFT_UPDATE.ZIP to a FAT32 formatted usb drive
Put the pendrive in to the HMI port
Wait for the pendrive icon appear on the top right corner of the screen
Go to SETTINGS and then UPGRADE menu
Press the RESCAN button until UPDATE FROM PENDRIVE appears
Tap the UPDATE FROM PENDRIVE to start the update process
Update is automatic, when it is ready, click on the UPDATE FINISHED OK button

Troubleshooting:
If the FW update run into error, please do the following:

Turn off the printer
With a piece of filament push and hold the reset button (a little hole under the ethernet port)
Turn on the printer
Release the button
Install the FW as above