Octopi / Octoprint is a web based 3D printer management solution.
You can find information and setting up the OctoPi or OctoPrint device here: https://octoprint.org/download/
On Craftbot side we recommend a good quality USB cable to connect the OctoPi device with Craftbot.
These are the settings available from pr3Dator_firmware_2019-03-06. But please always use the latest FW on your printer, you can download here: https://craftbot.com/firmware
When you setup the OctoP(i)rint please include this settings in the GCODE-s
Before print job starts: T0 ; select head 1 M110 S1 ; initialize the printer and the display G28 ; Home all axes M1020 S1; Set queue 1
After print job completes: M110 S2 ; the printer steps into the default state
After print job is cancelled: M110 S2 ; the printer steps into the default state M84 ; disable motors M104 S0 T0 ; switch off head 1 heating M104 S0 T1 ; switch off head 2 heating M140 S0 ; switch off bed heating M106 S0 ; disable object fan
After print job is paused: G197 ; pause
Before print job is resumed: G198 ; resume
Please install the progress bar code (M73) octopi plugin to have the print percentage information on the display. You can download here: https://plugins.octoprint.org/plugins/m73progress/