CraftBot Support Page Help Center home page
Submit a request
Sign in
  1. CraftBot Support Page
  2. General
  3. Printers

Printers

Follow New articles New articles and comments
  • Filament
  • Available nozzles and their compatibility
  • Nozzle replacement
  • Finding the serial number of Craftbot printers
  • Which object orientation is the best?
  • My extrusion is very inconsistent
  • My printer will not extrude. What do I do?
  • The CraftBot is still attempting to print but has stopped extruding in the middle of my object.
  • My bed adhesion is terrible/The prints are not sticking to the bed. What do I do?
  • My Infill (the cross pattern inside my printed object) is a bit weak
  • Bulbous Blobs on my print! How and why?
  • I am getting continuous ripples in my print, what now? sometimes known as "Ghosting"
  • Preventing gaps between the outer layer and the infill, or gaps in the outer layer itself
  • I am getting slots in the corners where two layers meet to form an angle...
  • The thin line between "too hot" and "not hot enough" -curling
  • How do I limit those marks on my print left after removing the supports?
  • I have layers separating!
  • My layers are shifting into different positions above one another! - Layershift
  • Stringing weblike strands of filament material over open areas
  • Overheating: "My print looks "melted and drippy" in places, especially in narrow sections"
  • Ringing -waves and shadows around sharp corners
  • Pillowing -little deformed pockets in my out layer
  • The outer shell layer has gaps
  • Grinding - My filament is being chipped away by the extruder gear! What to do?
  • Overhangs
  • Elephant foot -deformity where print touches the heated bed
  • In a few sentences, what is 3D printing?
  • Does 3D printing indoors produce toxic fumes?
  • Unpacking your CraftBot or Craftbot Plus printer
  • Fused Filament Fabrication (FFF), tell me all about it
  • 1
  • 2
  • ›
  • »
CraftBot Support Page